Do not run at overspeed or overpressure when driving a bulk cement truck. Overspeed and overpressure will seriously damage the air compressor. The maximum speed of this machine is shown in the main technical parameter table, and the working pressure is 0.2MPa.
1. Do not run at overspeed or overpressure when driving a bulk cement truck. Overspeed and overpressure will seriously damage the air compressor. The maximum speed of this machine is shown in the main technical parameter table, and the working pressure is 0.2MPa.
2. Do not start or stop the air compressor quickly, but increase or decelerate slowly, otherwise, the punching force will damage the air compressor.
3. Do not change the rotation direction of the air compressor, otherwise, the machine will be seriously damaged if the oil pump does not supply oil.
4. Do not stop the air compressor before decompression, otherwise, the powder material may flow back into the cylinder, causing serious damage to the air compressor.
5. Check the oil level before starting the machine. The oil level should not be lower than the lower limit of the oil mark; it is necessary to check whether the oil pump is supplying oil frequently. If it is not supplying oil, it should be stopped immediately for inspection.
6. Change the lubricating oil on schedule. After the new machine is used for 30 hours, drain the oil in the crankcase, clean the inside of the crankcase and the oil filter, and then change the oil. Change the oil once a year as above.
7. Check and clean the oil filter. Under normal circumstances, it should be checked and cleaned once a quarter. If the machine usage rate is high, it should be checked and cleaned once a month.
8. The lubricating oil used in this machine is CD40 diesel oil. It is forbidden to mix different grades of lubricating oil, otherwise the deterioration of lubricating oil will affect the lubricating effect.
9. Maintain and clean the air filter element every 30 hours of work. While rotating the filter element, blow it from the inside to the outside with compressed air with a pressure less than 0.6MPa. After five maintenances, replace the filter element with a new one. Do not clean the filter element with oil or water.